Basin faucet is an indispensable sanitary ware in kitchen and bathroom. When the basin faucet is blocked or damaged, it will also cause "blockage" in normal daily life. When it needs to be disassembled to check the fault, the question is: how to disassemble the basin faucet? Is there anything to pay attention to when disassembling the basin faucet? Next, I will introduce the method of disassembling the basin faucet in detail.

 

1. Under what circumstances do you need to remove the basin faucet?

 

Blockage, leakage and inability to store water are the most common problems of basin faucets. Oversights in installation and improper use will lead to problems. When the following "symptoms" appear in the faucet at home, it is necessary to consider the problem of dismantling the basin faucet and repairing it. :

 

1. When some consumers use it, they find that if the plug of the basin is used to plug the mouth of the hose connecting the basin, the basin cannot store water. This is because when the basin faucet is installed, the contact part of the sink basin is not sealed and needs to be removed and sealed;

 

2. After closing the basin faucet, the water at the water outlet has been flowing all the time, and it can't stop at all. This is usually a problem with the valve core of the water inlet valve, the sealing ring at the bottom of the valve core is blocked by garbage, the sealing ring is damaged or the pipe is damaged. Impurities scratch the spool may cause this;

 

2. How to remove the basin faucet

 

The basin faucet is connected with the angle valve by the water inlet hose, and is fixed on the basin table by the tightening nut. When disassembling, it mainly starts from these two aspects:

 

1. Before starting to disassemble the basin faucet, find the water inlet valve. The water inlet valve is usually installed on the wall below the basin. Screw on the angle valve first to cut off the water, otherwise a large amount of running water will be wasted during the process of disassembling the basin faucet;

 

2. After screwing on the angle valve, there will still be some water left in the water pipe, open the faucet to discharge the remaining water;

 

3. When installing the basin faucet, use the water inlet hose to connect the water inlet port of the basin faucet with the angle valve. When disassembling, hold the water pipe with one hand, twist the wrench with the other hand, and remove the end of the water inlet hose connected to the basin faucet;

 

4. When installing the basin faucet, it needs to be tightened after connecting the water inlet hose; the nut will lock it, so after removing the water inlet hose, find the fastener of the basin faucet and unscrew it with pliers or a wrench, Remove the basin faucet.

 

3. Precautions for dismantling the basin faucet

 

1. In some households, the hose under the faucet is very deep in the pipe, and it takes a certain amount of time to disassemble it. This is because the valve plug seat may be screwed onto the faucet body during installation. You can use a relatively long screwdriver to unscrew the screw counterclockwise from the bottom, and then push the valve core seat and high-pressure hose out from the bottom up. Pay attention to avoid damage to the sealing ring on the valve core seat before disassembling. hose;

 

2. Some water inlet hoses have been used for a long time, and the water inlet hose cannot be unscrewed temporarily due to embrittlement or rusted fasteners. You can put two or three drops of oil on the rusted part, and then take out the basin faucet.

 

How to disassemble the basin faucet? The above is the detailed disassembly process of the basin faucet. In addition, after normal use, clean the basin connection in time to avoid sharp objects from flowing into the water inlet pipe, which can make the use more durable!